Bailey Bridge Launching Nose Frame

Bailey Bridge Launching Nose Frame

If you're launching a Bailey bridge across a gap without any falsework underneath, you need a bailey bridge launching nose frame. It's a lightweight, tapered extension truss that bolts to the leading end of the main span and reaches ahead of it, so the bridge can be pushed or launched across a river, ravine, or railway cutting cleanly. We keep it shallower and lighter than the main truss on purpose — its only real job is to touch down on the far abutment and act as a guide rail while the heavy span follows behind.
Send Inquiry
Description
Technical Parameters

Product Introduction

 

If you're launching a Bailey bridge across a gap without any falsework underneath, you need a bailey bridge launching nose frame. It's a lightweight, tapered extension truss that bolts to the leading end of the main span and reaches ahead of it, so the bridge can be pushed or launched across a river, ravine, or railway cutting cleanly. We keep it shallower and lighter than the main truss on purpose - its only real job is to touch down on the far abutment and act as a guide rail while the heavy span follows behind.

Once the main span is landed, the nose gets unbolted and taken away. For any incremental-launch job it's the piece of kit that saves you the time and money of building ground-based falsework in the gap.

 

Features

 

Cuts down or wipes out the need for falsework or trestles sitting in the gap. The bailey bridge launching nose frame makes this practical.

Light build keeps the dead load low during launch, so the pushing force stays manageable

Tapered tip geometry means it lands smoothly on the far abutment bearing

Bolted pin connections let you attach and detach it in a hurry

You can use the same nose on bridge after bridge

Galvanized finish holds up through a long erection window outdoors

Can be built from standard Bailey panels (lightweight config) or purpose-made

 

Working Principle

 

Picture the launch. The main Bailey bridge is assembled back on one abutment and shoved horizontally toward the far side. Without a nose, the leading edge would sag under its own weight as it hangs out over the gap - it might slap into the water or ground before it ever got there. The nose fixes that by throwing a light, stiff truss out ahead of the span. The bailey bridge launching nose frame is built for this.

As the crew pushes, the nose reaches further and further across. Because it's light and doesn't deflect much, it makes it to the far abutment while the main span is still sitting fully supported on the near side. The moment the tip touches down, it becomes a support rail. Pushing goes on: the nose now carries the weight of the advancing main span across the gap, through itself, and onto the far abutment. The span "walks" across, leaning sometimes on the near-side rollers, sometimes on the nose, sometimes on the far bearings. When it's finally home on both abutments, we unbolt the nose, pull it off, and put the deck and appurtenances on.

 

Applications

 

Incremental launching of Bailey bridges over rivers, ravines, or railway cuttings. The bailey bridge launching nose frame makes this practical.

Crossings where falsework would be too costly or too hard on the environment

Urban bridge replacement where you can't shut down live traffic or rail below

Military bridging that has to go in fast without heavy crane support

Bridges over deep water where trestle piers don't pencil out

Staged construction where the new bridge launches right next to the old one

Hot Tags: bailey bridge launching nose frame, China bailey bridge launching nose frame manufacturers, suppliers, factory, 321 Bailey Bridge, bailey bridge, Compact 200 Bailey Steel Bridge, Compact 200 type Temporary Steel Bridge, Double Lane Bailey Steel Bridge, Single Lane Bailey Steel Bridge

Send Message