Product Introduction
If you're putting a Bailey bridge out where the bailey bridge wind tie rod assembly blows, these tie rod assemblies are the piece you don't want to skip. They're a set of high-strength longitudinal rods running the full length of the span, tying the top and bottom chord nodes of the two parallel trusses together. Sway bracing frames (our product 75) stiffen the bridge at discrete cross-sections; the wind tie rods do something different - they run continuously, joining the two trusses lengthwise and spreading wind load along the whole bridge rather than just at a few points.
We build them as adjustable steel-bar systems with turnbuckle tensioners, so your crew can tension them in the field and take out the slack. For any Bailey exposed to highway-speed wind, they're basically standard issue.
Features
Longitudinal tie rods spread wind load evenly along the full bridge length. The bailey bridge wind tie rod assembly makes this practical.
Turnbuckles let you tension the rods in the field and kill the slack
Top and bottom chord rods together resist both racking and torsional distortion
Galvanized rods and fittings shrug off outdoor corrosion
Bolted clevis connections go in fast with no welding
Each rod's high tensile strength handles design wind loads up to 1.5 kN/m²
Works with both single-storey and multi-storey Bailey configurations
Working Principle
Picture the wind hitting the bridge broadside. It pushes on the deck, the vehicles, and the truss faces, and all of that becomes a sideways force. Without these rods, each truss would fight that force on its own. The trusses aren't rigidly joined along their length, so they'd deflect by different amounts and the whole bridge would skew or rack. The bailey bridge wind tie rod assembly is built for this.
The tie rod assembly stops that by linking the two trusses at every single panel point. At each point you fit two rods: one tying the top chord nodes of the two trusses, one tying the bottom chord nodes. When the wind shoves the bridge sideways, the rods on the leeward side pull into tension and draw the two trusses together, forcing them to move as one. The turnbuckles along each rod are what let the erector tension everything evenly so there's no slack to start with. And when the load is torsional - say wind on one side plus an off-center truck - the top and bottom rods act as a couple and resist the rotation of the cross-section. Add the sway bracing frames at the cross-sections and you've got a fully braced box that behaves like a single rigid body under any lateral load.
Applications
Bailey bridges in open terrain facing high wind speeds. The bailey bridge wind tie rod assembly makes this practical.
Coastal bridges exposed to storm surge and typhoon-force winds
Long-span Bailey bridges (30 m+) where lateral stability is the design constraint
Railway temporary bridges with narrow decks and low torsional stiffness
Military bridges in desert or prairie environments with heavy wind
Permanent Bailey bridges in cyclone- or tornado-prone regions

