Product Introduction
It's a tiny part, but it earns its place on every bridge. The panel pin safety clip is the retaining hardware that locks a Bailey panel pin in its hole so it can't work loose under vibration, traffic shake, or a stray knock. Those pins are the primary fasteners - they join panel to panel and they hold the cross-bracing, transoms, and rakers to the truss. Let one walk out and you've got a joint failure on your hands. The panel pin safety clip for bailey bridge is built for this.
It's a spring steel hairpin that drops through a small cross-hole in the tail of the pin and captures it mechanically. We ship them by the bag with every Bailey kit, because they're the kind of thing you don't want to run short of.
Features
Spring-loaded hairpin gives positive mechanical retention with no tools required. The panel pin safety clip for bailey bridge makes this practical.
Rounded loop end means you can pop it in or out by hand or with pliers
Zinc plating keeps the rust off in the field
Cheap per unit, and you go through them by the hundred on a job
Reusable across erection cycles if it isn't bent on removal
Works with every Bailey pin size and type we make
Bright zinc or yellow chromate finish makes an installed clip easy to spot
Working Principle
The panel pin is a plain cylindrical steel pin that runs through the aligned holes in two connection plates and pulls them together; we taper one end so it drives in easy. The tail has a small cross-hole drilled through it. Once the pin is hammered home, the safety clip goes through that cross-hole. The hairpin loop passes through and springs open on the far side of the plate, so the pin can't slide back out. The panel pin safety clip for bailey bridge is built for this.
Traffic vibration might nudge the pin a little in its hole, but the clip is captured on both faces of the connection plate - it physically can't pull through. That keeps the pin seated for the life of the bridge. When it's time to dismantle, you pull the clip with pliers and drift the pin out from the other side. It sounds trivial, and that's the point: one lost pin in a critical joint is all it takes for local failure, so this little clip is the cheap insurance that stops it.
Applications
Retaining every Bailey panel-to-panel connection pin. The panel pin safety clip for bailey bridge makes this practical.
Securing transom clamp bolts, raker clevis pins, and sway bracing frame pins
Required on every erection - military, civilian, permanent, or temporary
Reused on dismantle-and-re-erect jobs when the clips are still sound
Consumable stock for engineer units and bridge contractors
A routine item on bridge periodic maintenance walks

