S460 Steel Modular Bridge

S460 Steel Modular Bridge

The system runs on the same pinned-panel truss logic as the classic Bailey, but S460's strength and fatigue behavior do the heavy lifting. Two parallel Warren-type trusses are each built from 1.524 m modules pinned end-to-end. Under gravity, the top chord compresses, the bottom chord tensions, and the diagonal webs carry shear. Because the yield is 460 MPa, the chords can be thinner-walled and still resist the same factored forces — and that's the whole point. The s460 steel modular bridge is built for this.
Send Inquiry
Description
Technical Parameters

Product Introduction

 

The S460 modular bridge is where we push the span-to-weight ratio as far as practical. It's built from S460 (EN 10025-4, thermomechanically rolled) fine-grain steel, with a 460 MPa minimum yield - about 30% above S355JR and nearly double mild steel. That lets the same truss geometry reach well beyond a standard Bailey span while carrying less of its own weight. The s460 steel modular bridge is built for this.

We keep the proven Bailey module format but trim the section sizes and rework the welded nodal details for high-strength steel. It's aimed at the jobs where dead weight is the enemy: long-span temporary crossings, floating bridges, or spans launched over rough ground, where the premium steel pays for itself by cutting erection and foundation cost.

 

Features

 

S460 thermomechanical steel brings 460 MPa yield with good toughness down to −40 °C. The s460 steel modular bridge makes this practical.

Thin-walled optimized sections cut dead weight 25–30% versus an S355JR equivalent

Longer single-storey spans - 40 m against the standard Bailey's 30 m

Easy to weld, with low carbon equivalent (CEV ≤ 0.45) simplifying fabrication

Fine-grain microstructure slows fatigue crack growth

Full mill test certificates (EN 10204 3.1) with every batch

Galvanized plus optional epoxy suits coastal and corrosive sites

Panel connections stay compatible with standard Bailey hardware

 

Working Principle

 

The system runs on the same pinned-panel truss logic as the classic Bailey, but S460's strength and fatigue behavior do the heavy lifting. Two parallel Warren-type trusses are each built from 1.524 m modules pinned end-to-end. Under gravity, the top chord compresses, the bottom chord tensions, and the diagonal webs carry shear. Because the yield is 460 MPa, the chords can be thinner-walled and still resist the same factored forces - and that's the whole point. The s460 steel modular bridge is built for this.

Self-weight is a big slice of the total load on a long span, so trimming it matters. Drop the dead weight and you either stretch the span or raise the live-load rating at the same span. The thermomechanical rolling also leaves a fine-grained structure that stays tough in the cold and resists fatigue cracking at the welds. The nodal joints still use the standard 50 mm Bailey pins for hardware commonality, but the welded gusset plates at the panel ends are detailed to S460-specific weld rules so the toes don't crack prematurely.

 

Applications

 

Long-span temporary bridges (40–80 m) where a standard Bailey needs multiple piers. The s460 steel modular bridge makes this practical.

Floating bridges where less pontoon displacement helps

Incrementally launched bridges over deep valleys or wide rivers

Arctic or cold-region bridges needing −40 °C toughness

Rapid military bridging where lighter weight eases air and road transport

Permanent modular bridges in remote spots where foundations are expensive

Hot Tags: s460 steel modular bridge, China s460 steel modular bridge manufacturers, suppliers, factory, 321 Bailey Bridge, bailey bridge, Compact 200 Bailey Steel Bridge, Compact 200 type Temporary Steel Bridge, Double Lane Bailey Steel Bridge, Single Lane Bailey Steel Bridge

Send Message